YAG Laser Tattoo Removal - Types, Procedures, and Results

YAG Laser Tattoo Removal - Types, Procedures, and Results

A YAG laser tattoo removal procedure is also known as the CTC (continuous toner transfer) method.multifunctional nd yag laser tattoo removal picosecond YAG stands for yttrium aluminum garnet and uses pulses of light, which break down the pigment in the skin and allow the body to absorb the heat. This heat and light are then transferred to the patient's bloodstream, where it is safely eliminated from the body through the vein to ensure no permanent damage is done to surrounding tissue.

The typical method used for this type of treatment is called the CTC (continuous toner transfer).multifunctional nd yag laser tattoo removal picosecond multifunctional nd yag laser tattoo removal picosecond This is because it is usually the continuous transfer of a high-energy light beam from a CTC device across the skin, using it to break down the pigment in the skin, making it easier for the body to absorb the heat from the light. The contrast between the color of the skin and the intense light from the laser makes the skin susceptible to inflammation. If the skin is not properly prepared, the laser can cause damage to surrounding tissue.

The light energy used by this treatment can range from around 300 milliwatts to thousands of watts. Most patients are treated using up to 500 milliwatts. When the body is exposed to a series of intense pulses of light, the skin becomes very sensitive to pain. Because of this, treatments are often done several times, with the removal process being performed in one sitting.

The type of treatment used for YAG laser tattoo removal is based on the amount of pigmentation present on the skin, and is usually the continuous use of pulsed light treatments which break down the pigment and absorb it into the bloodstream. The effectiveness of the treatment depends on the patient's skin type, and it takes months for results to be seen. Some patients may see small changes within hours of treatment, while others may have to wait for up to six months for full results. The time it takes for a patient to see the best results are largely dependent on the type of skin the laser is being used on.

There are several basic steps, which are typically taken before any treatments are performed. In order to get the best results, the patient should take the following steps:

Safety is important. Before each treatment, it is imperative that the patient is given adequate time to get to a hospital emergency room if needed. The ability to reach the hospital immediately should not be delayed, because this will provide the quickest results.

It is also recommended that the skin is properly hydrated before the treatment begins. The skin should be clean and dry, as even a minimal amount of moisture in the skin may cause the laser to work harder to achieve a satisfactory result. This may lead to uneven results, which may make it difficult to see results. After the treatment, the skin should be allowed to dry naturally.

The YAG laser tattoo removal procedure works best when the skin is not irritated, red, or swollen, as these conditions will prevent the treatment from working properly. A professional patient can expect to see results in two to three treatments, but this is usually dependent on the skin type of the patient.